The EV-TEST100 Test Adapter is a three and one phase testing adapter. In fact, the EV-TEST100 Testing Adapter has a type 2 connector to check the effectiveness of protective measures at e-charging stations for electric cars; and also to simulate the charge levels.
Moreover, if you combinate the EV-TEST100 Test Adapter with an appropriate HT Instruments multifunction instrument; it can simulate an electric vehicle connected to the charging station which allows you to verify the electric safety and the EVSE full functionality.
To illustrate, the HT Instruments has developed the EV-TEST100 EVSE Adapter for Electric Vehicle Charger Testing as an accessory for testing e-charging stations. Actually, you may use it for simulating charge states; and also for checking the effectiveness of protective measures at type 3 e-charging stations with a type 2 connector (European standard).
Equally important, the EV-TEST100 EVSE Adapter for Electric Vehicle Charger Testing offers an extensive range of features; that distinguish this quality product and make suitable for almost every application.
Features of EV-TEST100
- Use for EVSE charging stations: Charging modes 2 and 3
- Vehicle simulation via Control Pilot (CP state): States A, B, C, D
- Test cable with connector: Type 2 (IEC 62196-2)
- Fault condition simulation on PE: FAULT PE
- Simulating the current capacity of Proximity Pilot (PP state): NC, 13A, 30A, 32A, 63A
- EVSE internal counter efficiency check: LOAD
- Diode simulation in short circuit: FAULT E
- External load L-N-PE: 240V 50/60Hz, Max 10A AC
- Input voltage: Max 415V AC, Phase-Phase, 50 / 60Hz
- External load protection: Fuse FF 10A / 250V, 5x20mm
- CP signal: PWM 12V
- Operating humidity: <80&RH
- Operating temperature: 0°C ÷ 40°C
- Standards: IEC/EN61010-1, IEC/EN61851-1 and IEC/EN60364-7-722
At last, you may combine the HTI EV-TEST100 EV Testing Adapter the following models of the HT Instruments family: COMBIG3, COMBITOUCH, MFT-PRO, MT-300, COMBITEST425, MACROTOUCH, COMBIG2 COMBIG2PLUS and COMBI G3 MET-5035M.
In Brief, the EV-TEST100 Testing Adapter offers many measurement functions including Simulation of FAULT PE and CP, Monitoring of PWM output; Verification of Control Pilot, Verification of Proximity Pilot and Mechanical Interlock.